ESP DIGI-VIEW 4 System Manuel d'utilisateur télécharger pdf (Page 4)

In the Computer Administration section, click Monitor & Display.

3.2. Network settings

To establish the connection between the development computer and the hardware target platform, both

devices must be physically connected to the same network and have IP addresses of the same subnet.

To configure the target’s network settings, contact your network administrator for this information:

• IP address for the host computer's Ethernet card.

If the hardware target platform has an Ethernet interface:

• IP address for the target’s wired Ethernet. This IP address must be in the same subnet as the

host computer.

• Subnet mask for the Ethernet interface.

And in case of having a wireless capable module:

• IP address for the target's WLAN interface; that is, a free IP address of the wireless network.

• Subnet mask for the Wireless interface.

If a DHCP server is installed in the network, there is no need to request the

wired IP addresses. They are automatically assigned by the DHCP server.

1 2 3 4 5 6 7 8 9 ... 29 30

Pas de commentaire

ESP DIGI-VIEW 4 System Manuel d'utilisateur Page 4